Eachine Wizard X220S FPV Racer RC Drone Omnibus F4 5.8G 72CH 30A Dshot600 2206 2300KV 800TVL CCD ARF
|Eachine Wizard X220S|| |
Frame arm: 4mm carbon fiber
Weigh: 356g (without battery and camera mount)
Take off weigh: 561g
3K carbon fiber frame kit, 4mm thickness and 15mm width frame arms, the width is 10mm less than Eachine Wizard X220.
Frame kit with camera angle scale and 30° camera mount for Runcam 3 Gopro session.
Anti-vibration sponges to protect the racer frome crashing.
|Eachine MN2206 2300KV motor|| |
Max thrust: 1100G
NO.OF cell: 3-5S
Propeller: 5 inch
|Eachine 30A BLHELI_S 4 in 1 ESC|| |
Con. current: 30A
Peak current (10S): 35A
Input voltage: 2-5S
BEC: 5V output
|Eachine 1179 800TVL CCD camera|| |
Resolution(horizontal center): 800TVL
Shell size: 25mm*25mm
Resolution: PAL: 1980H×1080 (2MP)
Video output: 1.0Vp-p/75Ω
Automatic gain control: 0.25/0.50/0.75/1.00 adjustable, up to 55dB.
Exposure mode: electron exposure
Electronic shutter: 1/50(1/60) - 1/100000 S
Gamma correction: 0.45/1.0
Synchronization method: internal synchronization
Lens: standard 2.8mm lens
Working voltage: DC12V (Wide Voltage, measured that can be work in 5-13V)
Workig current: 70mA (low power consumption)
Workig temperature: -20℃--60℃
Humidity: 0%~98%Strong backlighting effect
| 5.8G 72CH 25MW 200mw 600MW |
Video Format : NTSC/PAL
Operating Temperature : -10~85℃
Connector: RP-SMA Female
Antenna connector: RP-SMA Male
|Omnibus F4 V3 flight controller|| |
Mount holes: 30.5x30.5mm
STM32 F405 MCU, Runs Betaflight 3.0.1 firmware, could run faster loop time.
Using F4 MCU controls OSD over SPI bus in DMA mode.
OSD Configation has been included in Betaflight GUI.
SBUS/PPM input (Pinheaders)
6PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders)
SPI Sensor MPU6000
Included 128Mbit Flash, please always use BEC for the FC.
Supported by BETAFLIGHT and dRonin
|Eachine 5051 3-blade propeller|| |
Quantity: 10 Pairs
Mounting Hole: 5mm
This is the ARF version that comes without battery, charger, receiver and remote control.